The BS1345 of the British Standards Institution was published in 1945 a survey by the British Board of Trade stated the need for 126 sizes to cover its female population. Soon after the CS215–58 was developed, several countries built their sizing standards or published reports on the subjects. It was then recommended that in order to assure purchasers that garments conform to this system, such garments be identified by a sticker, tag, or a hanger or other label carrying the type of information presented above: 14 T– or 14R or 14S +. So instead of referring to a size 14 as for misses, it would be a junior size 13. One last detail of the report was that the junior classification was based upon interpolations of portions of the data used in the development of the misses’ classification and therefore has traditional odd numbers for size designations.
#True measure of a man clothing full
For example: ‘14 T–’ would refer to a size 14 bust, T for tall in height and ‘–’ for slender hip type whereas a size designation of ‘14R’ would mean: size 14 bust (with its underlying measurements), R for regular in height and an average hip type or again ‘14S+’ which would refer to a size 14 bust, S for short in height, and ‘+’ for full hip type.
The size number and symbols were combined to make the complete size designation. The report itself proposed various possible applications, definitions of the measurement points, measuring methods, sizing charts and the percentage of women in each of these classes. Then again with four sub-groups within each of these groups: ‘bust-hip’, ‘slender’, ‘average’ and ‘full’. This was followed by groups defined as: ‘short’, ‘regular’ and ‘tall’. Four classifications of women: ‘misses’, ‘women’, ‘half-sizes’ and ‘junior’. The CS215-58 reports the scopes as follows. To provide the consumer with a means of identifying her body type and size from the wide range of body types covered, and enable her to be fitted properly by the same size regardless of the price, type of apparel, or manufacturer of the garment. The measurements given in this standard are body, not garment, measurements and 2.
To provide standard classification, size designations, and body measurements for consistent sizing of women’s ready-to-wear apparel (Misses’, Women’s, Juniors’, etc.) for the guidance of those engaged in producing or preparing specifications for patterns and ready-to-wear garments. Then, its primary and secondary goals were: 1. Although interesting and useful, the statement was as follows: ‘The adoption and use of a Commercial Standard is voluntary’. It was in 1958 that The US Department of commerce published the Body Measurements for the Sizing of Women’s Patterns and Apparel, The commercial standard ‘CS215-58’. Furthermore, in 1945, the Association for Mail-order Sales recommended a standard way for labeling size designations for the garment industry. These resulted from the cooperation of various interest groups which fulfilled a perceived need within the industry ( Kadolph, 1998). 1.īody measurements of the national survey were compiled in order to develop size designation and to facilitate commercial communication. There are five stages in developing size charts for garments, as described below. 10–12–14–16, or labelled small, medium, and large. These average body measurements are obtained from surveys of body measurements. Size chart formulation begins with the division of average body measurements artificially into categories to form a range of sizes. From the data collected, the development of size charts for pattern grading and garment production begins. Whichever method is used, the first consideration is to decide which measurements are required.
#True measure of a man clothing manual
The techniques of body scanning are constantly improving and will supersede manual methods in the future. Manual measuring requires a high degree of skill and is time consuming. At present, we are in the transition between traditional manual measuring by tape measure and computerised body scanning or using photographic systems. The size and fit of a garment depends upon the accuracy. Body measurements are a prerequisite to pattern construction.
0 kommentar(er)
